Car Capsule Setup

Instructions for CarCapsule Set-Up

Remove CarCapsule from box. 

Unroll and spread out the base mat.  Unzip the upper shroud from the base mat.  Roll the upper shroud off of the base mat, exposing the area to which the base mat attaches to the upper shroud.

Pull the vehicle on to the base mat.

Unroll the upper shroud over the vehicle.  Pull the bottom of the upper shroud until it meets the base mat.  Place the fan in place making sure the Velcro® is fully attached.

Zip the upper shroud to the base mat. 

Plug the fan into the adaptor provided.  CarCapsule should take just a few minutes to inflate.  Once it's fully inflated, place the filter in the opening surrounding the fan.

1. Select your place of set up by considering the following:

The start of zipper location should also be located near an electrical outlet.
The air intake should be away from outside doors and heat sources.
The surface should be as flat as possible.
The base mat should be located with all sides accessible to work the zippers .

2.   We have included two Styrofoam tubes to place over the zipper.

When these are in place, your vehicle will not damage the nylon zipper when rolling it onto the mat.  Roll the vehicle onto the base mat leaving equal distance on all sides. Please note: Take care not to turn the steering wheel while the vehicle is on the base mat. 
If the exhaust system is hot, be very careful not to allow it to touch any part of the CarCapsule.

3.   Insert the fan panel into position, smooth out the Velcro.

4.   Push the male connector thru the slit in the base mat. 

Connect the male end to the female end connector of the fan motor.

5.   Starting at the fan end, carefully drape the clear center section over the vehicle's hood, roof and trunk. Zip both zippers closed securing the tops and sides. 

6.   Plug the 12V transformer into your wall outlet and your CarCapsule will start to inflate.  After the bubble is completely inflated, insert the filter by pushing the brim inside the flap around the fan.

7.   To increase airflow thru the cover to dry wet vehicles or to regulate the air pressure in extremely hot weather, simply readjust the rear zipper closure to allow more air to flow through the capsule.  On average, the CarCapsule will change its air volume 3 to 4 times per hour.